Bridge

Connects two faces or two groups of faces in face mode, or connects two open edges. After the initial Bridge, you can adjust the number of segments and adjust the tension on either end to affect the bridge's curvature. Right clicking or picking the Accept check mark ends the command.

Available from Face or Edge Mode.

The top sequence of images below show: 1) select two faces one on front and one on back side of the mesh; 2) Bridge the selected faces to make a hole;

The second row of images shows an exterior bridge of two faces then the changing the strength of the left side from 100 to 300 and the right side to 20.

The third row of images demonstrates bridge of 3 edges on either side. The right image on the bottom shows increasing the number of segments to 3.

Created with the Personal Edition of HelpNDoc: Full-featured Documentation generator